Bryant's new line of high-quality motor controller/disconnects provides the control you need with the features and flexibility you expect.

Bryant's combination motor controller/disconnect devices utilize one switch to function as both a motor controller and a motor disconnect as defined in the National Electrical Code (NEC) article 430.102. Since the new device is "suitable as a disconnect" as described in the NEC, users gain the economy, convenience and simplicity of using just one device to satisfy two requirements.

Motor controllers are designed to simply switch motor loads on and off thousands of times. Motor disconnects, however, are designed to safely terminate power to a motor load for servicing, and are tested to withstand high short-circuit current faults. Because the 2005 NEC requires each controller to also have a disconnect installed in the circuit within "line of sight," (article 430.102), two devices were previously needed to meet the code. Since the NEC also recognizes that the controller and disconnect can be the same unit (art 403.109), Bryant's new line of devices, rated for 10,000 Amp short circuit current, now provide a safe, economical solution in one device eliminating confusion and the need for an extra disconnecting means.

Bryant's unique design provides:

• The ability to install one switch at the controller location eliminating additional labor and material previously needed to meet NEC requirements.
• Flexibility for installation since the NEC "line of sight" requirements can now be met at the equipment or on a nearby panel or wall.
• Economy in size. Smaller switches operating as both controllers and disconnects.
• A variety of enclosures to meet specific application requirements.
• Code compliance with smaller devices performing multiple tasks.
• Productivity improvement by allowing maintenance and repair of motor loads at isolated points in the circuit without the inconvenience and high cost of shutting down an entire line.

For additional information on the new line of Bryant motor controllers/disconnects, visit www.bryant-electric.com, contact your local Bryant representative or Bryant Customer Service at 800-323-2792. Request a copy of the new motor controller/disconnect brochure (BPB101).